Saturday, January 08, 2011
It took about 4 hours to lay up all the carbon on the frame. Below are a series of photos of the layering.
I start each joint with a long continuous layer along the joint.
Lots of layers later...
Again, one long layer to start.
The seat tube junction had a few fewer layers.
The flash breaker tape should help with maintaining the "lug" edge after curing.
A lot of cutting little pieces of carbon. I think I need some woven cloth or 300g/m^2 uni.
Share to Twitter
Share to Facebook
Share to Pinterest
Post a Comment
Post Comments (Atom)